Unifi controller port 8080 is used by other programs

Unifi controller port 8080 is used by other programs password#

Use Putty to open an SSH connection to the USG at 192.168.1.1 with the default username password вЂњubntвЂќ/вЂќubntвЂќ. On the first computer, open a connection to the management interface of the remote controller.Д¬hange the IP address of the second computer to 192.168.1.10. The LAN port is used for configuring the USG.The WAN port must be able to pull (via DHCP) an IP address that lets the USG connect to the Internet.Plug both the WAN and LAN ports of the USG into your local switch, behind your local router: In your local office, youвЂ™ll need two computers, four network cables, a switch and a router connected to the Internet. When I was struggling to get this to work, I updated the controller to version 5.8.24. If you are using to access the remote controller, you do not need to open TCP port 8443 in fact, this article recommends that, for security reasons, you donвЂ™t open that management port. but IвЂ™ve seen one instance where I had to open firewall ports explicitly. Theoretically you shouldnвЂ™t need to open port 8080 in that computerвЂ™s Windows firewall. On the remote router, forward that port to the computer running the controller. The USG must be able to reach the remote controller on the вЂњinform port,вЂќ TCP 8080 by default. UniFi documents remote adoption for access points here, but there is apparently no documentation on adopting USG devices or switches. This qualifies as a вЂњremote adoptionвЂќ or вЂње…ѓ adoption.вЂќ IвЂ™ve spent several frustrating hours over a period of many days trying to get this to work.

TheyвЂ™re ready to add a USG router, which I want to configure in my office before going on site. My customer has a UniFi controller running on their Windows server.

Unifi controller port 8080 is used by other programs